One of the innovative new features of the MCS® 151 and MCS® 251 microcontrollers is page mode. Page mode increases performance by up to 2X by reducing the time for external code fetches.

Under page mode configuration, the data base (D7:0) is multiplexed with a higher address byte (A15:8) on port 2 instead of being multiplexed with a lower address byte (A7:0) on port 0. With this configuration, the controller is able to fetch an instruction from external memory in two clocks instead of four. The MCS 151 and MCS 251 microcontrollers default to non-page mode for pin compatibility with the MCS® 51 microcontroller. To enable page mode, users have to configure or program the “page” bit in the Uconfig0 configuration byte to zero. Page mode does not affect internal code fetches.

The first code fetch to a 256-byte “page” of memory always uses a four-clock bus cycle. Subsequent successive code fetches to the same page (page hits) require only a two-clock bus cycle. When a subsequent fetch is to a different page (a page miss), it again requires a four-clock bus cycle.

The page-miss cycle is the same as a code fetch cycle in nonpage mode. For the page-hit cycle, the upper eight address bits are the same as for the preceding cycle. However, a page hit reduces the available address access time by two clocks. Therefore, faster memories may be required to support page mode.

8XC251SA, 8XC251SB, 8XC251SP, 8XC251SQ Embedded Microcontroller User's Manual (.pdf 3,118,443 bytes)

Legal Stuff © 1997 Intel Corporation